Epson TX103 Error E11 Fix – Reset Ink Pad Counter via USB
Your Epson TX103 may halt with Error E11 or Service required when the waste ink counter is full. Clear it using WicReset Connect in about 2 minutes. Keys start at 6 EUR. Windows 7–11 (USB).
Typical Signs on Epson TX103
- Printer refuses to print, LEDs flashing.
- Shows Error E11 or Service required.
- Displays warning: Ink Pad Needs Service.
Why Epson TX103 stops
Epson TX103 throws a service lock when its waste ink counter reaches the limit. A simple counter reset often resolves it; it doesn’t always mean the pads are truly at end of life.
Quick facts – Epson TX103 reset
| Model | Error | Solution | OS | Reset time |
|---|---|---|---|---|
| Epson TX103 | Error E11 / Ink Pad Needs Service | WicReset Connect | Windows 7–11 (USB only) | ~2 minutes |
Download reset tool & driver
No verified official Epson driver found for Epson TX103. Please refer to Epson Setup Navi for compatible software.
Video tutorial
Available in many languages with narration.
Reset steps for Epson TX103
- Connect Epson TX103 to your PC via USB cable.
- Launch WicReset Connect and ensure the printer is detected.
- Buy a reset key, input it, and click Reset.
- Wait ~2 minutes, then turn the printer off and on again.
FAQ – Epson TX103
Why blocked if pads aren’t full?
The counter is an estimate; it can lock before physical saturation.
Does resetting change ink levels?
No — it affects only the waste ink counter.
Can I reset over a USB hub?
Use a direct, high-quality USB cable for best stability.
Will I lose settings?
No — network/print settings remain.
Can I print immediately after reset?
Yes — power-cycle the printer and it’s ready.
Tips for Epson TX103 reset
- Reset around ~95% to avoid full lock.
- Reduce unnecessary head cleanings.
- Use a short, high-quality USB cable for stability.
This page is dedicated to Epson TX103 reset instructions using WicReset Connect.