How to Reset Epson L3200 – Fix “Service Required” / Error E11
Quick solution with WicReset Connect. Works on Windows 7–11 via USB connection.
🔑 Koupit klíč WicReset Connect
If your Epson L3200 stops working and shows Chyba E11 nebo “Požadovaná služba”, it means the počítadlo odpadního inkoustu reached its software limit. Pads are rarely full — the printer is just locked by firmware. You can fix this in a few minutes with WicReset Connect.
Typical symptoms on Epson L3200
- Printer displays “Požadovaná služba”.
- Error E11 appears and printing is blocked.
- Flashing red lights, no printing possible.
Why does Epson L3200 show this error?
The printer counts waste ink in an internal počítadlo odpadního inkoustu. When it hits 100%, the machine locks itself. Resetting the counter with WicReset Connect clears the error and restores normal use.
How to reset Epson L3200 with WicReset Connect
- Stažení a instalace WicReset Connect.
- Connect the L3200 to your PC with a Kabel USB (Wi-Fi not supported for reset).
- Run the program and enter your purchased WicReset Connect key.
- Klikněte na RESET and wait about 2 minutes.
- Turn the printer OFF for 10 seconds, then turn it back ON.
👉 Get your reset key here: Buy WicReset Connect key
FAQ – Epson L3200 Reset
Will this remove Error E11?
✅ Yes — resetting the counter clears Error E11 / “Service required”.
Musím vyměnit podložky?
Usually not. The counter is based on estimates, not actual pad saturation.
Is Wi-Fi reset possible?
❌ No, reset works only via USB.
What systems are supported?
Windows 7, 8, 10, 11 (32 & 64 bit).
Tips to prevent this issue
- Perform fewer unnecessary head cleanings.
- Always use a reliable USB cable during reset.
- Reset when the counter is ~95%, before the printer locks completely.
🔑 Koupit klíč WicReset Connect
English 
Čeština 
Deutsch 
Español 
Français 
Hrvatski 
Magyar 
Italiano 
Nederlands 
Português 
Slovenščina 
Українська