How to Reset Epson L3200 – Fix “Service Required” / Error E11
Quick solution with WicReset Conectar. Works on Windows 7–11 via USB connection.
If your Epson L3200 stops working and shows Erro E11 ou “Service required”, it means the contador de tinta residual reached its software limit. Pads are rarely full — the printer is just locked by firmware. You can fix this in a few minutes with WicReset Conectar.
Typical symptoms on Epson L3200
- Printer displays “Service required”.
- Error E11 appears and printing is blocked.
- Flashing red lights, no printing possible.
Why does Epson L3200 show this error?
The printer counts waste ink in an internal contador de tinta residual. When it hits 100%, the machine locks itself. Resetting the counter with WicReset Conectar clears the error and restores normal use.
How to reset Epson L3200 with WicReset Connect
- Download and install WicReset Conectar.
- Connect the L3200 to your PC with a Cabo USB (Wi-Fi not supported for reset).
- Run the program and enter your purchased WicReset Connect key.
- Clicar REINICIAR and wait about 2 minutes.
- Turn the printer OFF for 10 seconds, then turn it back ON.
👉 Get your reset key here: Buy WicReset Connect key
FAQ – Epson L3200 Reset
Will this remove Error E11?
✅ Yes — resetting the counter clears Error E11 / “Service required”.
Do I need to replace pads?
Usually not. The counter is based on estimates, not actual pad saturation.
Is Wi-Fi reset possible?
❌ No, reset works only via USB.
What systems are supported?
Windows 7, 8, 10, 11 (32 & 64 bit).
Tips to prevent this issue
- Perform fewer unnecessary head cleanings.
- Always use a reliable USB cable during reset.
- Reset when the counter is ~95%, before the printer locks completely.
English 
Čeština 
Deutsch 
Español 
Français 
Hrvatski 
Magyar 
Italiano 
Nederlands 
Português 
Slovenščina 
Українська