How to Reset Epson L3200 – Fix “Service Required” / Error E11
Quick solution with WicReset Connect. Works on Windows 7–11 via USB connection.
If your Epson L3200 stops working and shows Помилка E11 або “Потрібна послуга”, it means the лічильник відпрацьованого чорнила reached its software limit. Pads are rarely full — the printer is just locked by firmware. You can fix this in a few minutes with WicReset Connect.
Typical symptoms on Epson L3200
- Printer displays “Потрібна послуга”.
- Error E11 appears and printing is blocked.
- Flashing red lights, no printing possible.
Why does Epson L3200 show this error?
The printer counts waste ink in an internal лічильник відпрацьованого чорнила. When it hits 100%, the machine locks itself. Resetting the counter with WicReset Connect clears the error and restores normal use.
How to reset Epson L3200 with WicReset Connect
- Download and install WicReset Connect.
- Connect the L3200 to your PC with a USB-кабель (Wi-Fi not supported for reset).
- Run the program and enter your purchased WicReset Connect key.
- Клац! СКИДАННЯ and wait about 2 minutes.
- Turn the printer OFF for 10 seconds, then turn it back ON.
👉 Отримайте свій ключ перезавантаження тут: Купити ключ WicReset Connect
FAQ – Epson L3200 Reset
Will this remove Error E11?
✅ Yes — resetting the counter clears Error E11 / “Service required”.
Do I need to replace pads?
Usually not. The counter is based on estimates, not actual pad saturation.
Чи можливе скидання налаштувань Wi-Fi?
❌ No, reset works only via USB.
What systems are supported?
Windows 7, 8, 10, 11 (32 & 64 bit).
Tips to prevent this issue
- Perform fewer unnecessary head cleanings.
- Always use a reliable USB cable during reset.
- Reset when the counter is ~95%, before the printer locks completely.
English 
Čeština 
Deutsch 
Español 
Français 
Hrvatski 
Magyar 
Italiano 
Nederlands 
Português 
Slovenščina 
Українська